Change place and contents
Corrected errors in ECHO logic in Fig. 2.12-8 in
DISCAR
Corrected errors in ECHO logic in Fig. 2.13-7 in
DEFCAR
Added a missing signal monitoring point of SOTFOC-
TRIP in Fig 2.14-1
Corrected the EF plc monitoring points’ names in Table
2.16-5 and Figure 2.16-6 about EF1 and EF1PU
Corrected OCN plc monitoring points’ names in Table
2.17-5 and Figure 2.17-6 about OCN1 and OCN1PU
Corrected CB-phase-open incoming part in Fig 2.25-
4(UVS)
Added and revised the information about [INTCOMM]
in 2.37.4 (COMM_APPL)
Corrected the information at signal monitoring point of
LRSW01_LR_ST_RMT in Table 3.5-5
Corrected Total time (TTIM) setting names at No. 10,
11, and 12 items (010, 011, 012 -> 10, 11, 12)
Added delay timer settings [UTM] in PLC function
Added new information about [ErrorLED_cond] to turn
off In-service for the occurrence of minor error
Revised the contents about Commslv error information
in Automatic supervision function
Revised the setting menu hierarchy to include PLC
timer settings in Figure 12.2-2
Corrected signal numbers in Fig. 2.28-2 of ICD function
Revised information about U16_00 and U16_01
information
Revised information about quality signals in
IEC61850. Added default U16_00, U16_01 signals
Added default mapping information in Appendix 4:
IEC61850
Added metering displaying exercises on the MIMIC
screen
Revised the information about Quality_Validity in
Figure 11.3-29
Added new BIO codes (5U, 6H, 6J). Added the slot
number information for the remote protection
Corrected and revised about the 100Base-FX and other
comm. data in Appendix Technical data
Corrected current reversal logic of Fig. 2.13-3 in
DEFCAR function
Corrected and deleted an signal inversion logic of
SYNDIF function in Fig .4.6-14 and 15
Added the information about threshold settings when
24-60Vdc PWS is used in BI1A module
Added the information about 24-60Vdc setting and
jumpers in Table 5.5-2 in PWS
To Next Page
Loading...
