Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 101
8400 HighLine | Parameter setting & configuration
Motor control (MCTRL)
Motor selection/Motor data
Accepting the default values of the motor
If a motor is selected from the motor catalogue at a later time, the Use motor's default
values dialog box is displayed afterwards which includes all motor data of the selected
motor. Please select here which of the default values are to be copied to the controller:
Tip!
If a third party manufacturer's motor is used, select a Lenze motor from the motor
catalogue first which is similar in terms of current, voltage and speed rating. Adapt
the preselected motor data exactly to the real motor afterwards.
efesotomasyon.com - Lenze
To Next Page
Loading...