8400 HighLine | Parameter setting & configuration
Technology applications
Overview of available technology applications
260 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
7.2 Overview of available technology applications
Further technology applications are in preparation.
Technology application "Actuating drive speed"
This technology application serves to solve speed-controlled drive tasks, e.g.
conveyor drives (interconnected), extruders, test benches, vibrators,
travelling drives, presses, machining systems, metering units.
TA "Actuating drive speed"
( 262)
Technology application "Table positioning"
This technology application serves to solve position-controlled drive tasks
which are normally controlled by a higher-level control via a fieldbus, e.g.
transport facilities, rotary tables, storage and retrieval units, feed drives,
metering units, hoists.
Note: An external sequence control is required for this TA!
TA "Table positioning"
( 291)
Technology application "Switch-off positioning"
This technology application available from version V04.00.00 on serves to
solve speed-controlled drive tasks for which a pre-switch off or stop at certain
positions is required, e.g. roller conveyors and conveying belts. The pre-switch
off is realised by the connection of switch-off sensors.
TA "Switch-off positioning"
( 325)
efesotomasyon.com - Lenze
To Next Page
Loading...
Need help?
General
