EasyManuals Logo

Lenze E84AVHC Series User Manual

Lenze E84AVHC Series
1118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #71 background imageLoading...
Page #71 background image
Firmware 05.00 - DMS 4.2 EN - 02/2010 L 71
8400 HighLine | Parameter setting & configuration
Device control (DCTRL)
Controller commands
4.1.3 Save all parameter sets
If parameter settings are changed in the controller, those changes will be lost after mains
switching of the controller unless the settings have been saved explicitly.
The C00002/11
= "1: On / start" controller command saves the current parameter settings
safe against mains failure to the memory module of the controller.
How to save the parameter settings to the memory module:
Execute the Save all parameter sets controller command:
C00002/11
= "1: On / start"
The storage process may take a couple of seconds. After the controller command
has been called in C00002/11
, dynamic status information ("Work in progress
20%" "Work in progress 40%" "Work in progress 60%", etc.) is returned.
Tip!
This controller command can also be activated via the toolbar icon.
•The "Load Lenze setting
" controller command (C00002/1 = "1: On / start") resets
the parameter settings to the delivery status of the device.
Note!
When the device is switched on, all parameters are automatically loaded from
the memory module to the main memory of the controller.
Observe the following to avoid data inconsistencies which cause errors when the
parameters are loaded from the memory module:
During the storage process:
Do not switch off the supply voltage!
Do not remove the memory module from the device!
The controller is currently provided with one
data record for all parameters, i.e.
every parameter has a value. Several data records per controller are in
preparation.
efesotomasyon.com - Lenze

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lenze E84AVHC Series and is the answer not in the manual?

Lenze E84AVHC Series Specifications

General IconGeneral
BrandLenze
ModelE84AVHC Series
CategoryInverter Drive
LanguageEnglish

Related product manuals