8400 HighLine | Parameter setting & configuration
Function library
System blocks | LS_AnalogInput
1072 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
14.2.1 LS_AnalogInput
Interface to the analog input terminals.
14.2.2 LS_AnalogOutput
Interface to the analog output terminals.
14.2.3 LS_CANManagement
Control of internal functions of the CAN driver and display of the "Operational" state as
well as the node address.
14.2.4 LS_DataAccess
Only for Lenze-internal use.
14.2.5 LS_DeviceMonitor
Motor control status signals.
14.2.6 LS_DigitalInput
Interface to the digital input terminals.
For a detailed description see the main chapter "I/O terminals":
Internal interfaces | System block "LS_AnalogInput"
( 242)
For a detailed description see the main chapter "I/O terminals":
Internal interfaces | System block "LS_AnalogInput"
( 242)
For a detailed description see the main chapter "System bus CAN on board":
Internal interfaces | System block "LS_CANManagement"
( 571)
For a detailed description see the main chapter "Motor control (MCTRL)":
Internal status signals | system block "LS_DeviceMonitor"
( 214)
For a detailed description see the main chapter "I/O terminals":
Internal interfaces | System block "LS_DigitalInput"
( 229)
efesotomasyon.com - Lenze
To Next Page
Loading...