Lenze E84AVHC Series - 13.8 Copying an interconnection

8400 HighLine | Parameter setting & configuration
Working with the FB Editor
Copying an interconnection
870 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
13.8 Copying an interconnection
In contrast to copying/inserting selected interconnection elements via the clipboard, the
function described in this chapter serves to replace the current FB interconnection of a
device completely
by the FB interconnection of another project device.
A complete interconnection comprises:
 Function blocks (use and parameter values)
 System blocks (application and parameter values)
 Port blocks (use and parameter values)
 Connections
 Comments
 Interconnection layout (arrangement of the modules)
 Port definition of the ports used in the FB interconnection
 How to copy the complete interconnection into another project device:
1. Select the application with the FB interconnection to be copied in the project view.
2. Select the command Application dataCopy FB interconnections....
3. Go to project view and select the application which is to be inserted into the copied
FB interconnection.
4. Select the command Application dataAdd FB interconnection....
• The command can only be activated if an FB interconnection has been copied
from a device of the same device type and version.
• After the command has been executed, the module assembly is compared. If
there are relevant deviations, the insertion is refused and a corresponding
message is displayed.
• If an insertion is possible, you are asked if the FB interconnection is to be
inserted.
5. Confirm the question if the copied FB interconnection is to be inserted with Yes.
• After the insertion, an update of the project is required.
 Note!
The complete FB interconnection can only be copied between devices of the
same device type and version (e.g. 8400 HighLine C V1.0).
efesotomasyon.com - Lenze