Lenze E84AVHC Series - 9.9.2 Reset of error message

8400 HighLine | Parameter setting & configuration
Diagnostics & error management
Error messages of the operating system
474 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
9.9.2 Reset of error message
An error message with the response "Fault", "Trouble", "TroubleQSP" or "Warning locked"
must be explicitly reset (acknowledged) after the cause of the error has been eliminated.
 To reset (acknowledge) a pending error message, execute the controller command
C00002/19
="1".
 Tip!
With an online connection to the controller, use the Diagnostics tab of the
»Engineer« and click Error message reset to reset a pending error message.
efesotomasyon.com - Lenze