Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 31
8400 HighLine | Parameter setting & configuration
Introduction: Parameterising the controller
Handling the keypad
2.3 Handling the keypad
Use the keypad for quick and simple parameter setting and for displaying current actual
values and device states via the respective display parameters. For this purpose, plug in the
keypad onto the X6 diagnostic interface on the front of the standard device.
Danger!
In general, changing a parameter causes an immediate response in the
controller!
• This may lead to undesirable behaviour on the motor shaft if the controller
has been enabled!
• Setpoint sources, for instance, may switch over all of a sudden (e.g. when
configuring the signal source for the main setpoint).
Certain device commands or settings which may cause critical states of drive
behaviour constitute exceptions. Such parameter changes are only possible if
the controller is inhibited. Otherwise, a corresponding error message will be
issued.
Note!
Plugging and unplugging the keypad is possible during operation.
Detailed information on the keypad can be found in the operating instructions
accompanying the keypad!
efesotomasyon.com - Lenze
To Next Page
Loading...