Lenze E84AVHC Series - C00164 | Logbook - analog elements

8400 HighLine | Parameter setting & configuration
Parameter reference
Parameter list | C00164
620 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
C00164
86 MCI word 2 input bit 15
87 Position controller: Limit
88 Speed controller: Limit
89 Speed setpoint: Limit
90 Torque setpoint: Limit
91 Current setpoint: Limit
92 DC injection brake active
93 Quick stop is active
94 Pulse inhibit is active
95 Controller inhibit is active
96 Safe status active
97 Direction of rotation ccw
98 Actual speed = 0
99 L_Or_1: Out
100 L_DFlipFlop_1: Out
101 L_DigDelay_1: Out
102 L_Compare_1: Out
103 L_Compare_2: Out
104 L_NSet_1: Setpoint reached
105 L_DigitalLogic_1: Out
106 L_SignalMonitor_b: Out1
107 L_SignalMonitor_b: Out2
108 L_SignalMonitor_b: Out3
109 L_SignalMonitor_b: Out4
110 L_PCTRL_1: act=set
Subcodes Lenze setting Info
C00163/1 0: No signal Logbook binary element 1
C00163/2 0: No signal Logbook - binary element 2
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00163 | Logbook - binary elements
Data type: UNSIGNED_16
Index: 24412
d
= 5F5C
h
Parameter | Name:
C00164 | Logbook - analog elements
Data type: UNSIGNED_16
Index: 24411
d
= 5F5B
h
Selection of an analog signal that is to be logged in the logbook.
Selection list Info
0No signal
1AIN1
2CAN1 control word
3CAN1 input word 2
4CAN1 input word 3
5CAN1 input word 4
6CAN2 input word 1
7CAN2 input word 2
8CAN2 input word 3
9CAN2 input word 4
efesotomasyon.com - Lenze