Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 35
8400 HighLine | Parameter setting & configuration
Commissioning
Guide
3.1.2 Trouble during commissioning
If the »Engineer« is used, trouble during commissioning can be detected and eliminated
conveniently. Proceed as follows:
Check whether error messages appear in the »Engineer«.
– You can find a description of each possible message in the chapter entitled
"Diagnostics & error management
". ( 452)
Check the input terminals for their corresponding setpoints.
Check the signal flow of the application.
– To do this, open the Application Parameters tab and click on the Signal flow button.
The signal flow which is then shown enables a view of the setpoints being applied
and their processing.
efesotomasyon.com - Lenze
To Next Page
Loading...