8400 HighLine | Parameter setting & configuration
Commissioning
Guide
34 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
Commissioning using the »Engineer« engineering software is suitable
– for basically every drive task.
The »Engineer« is a tool which will support you throughout the entire life cycle of a
machine - from planning to maintenance. The support includes the online help
integrated into the »Engineer« and the software documentation provided in the
scope of supply of the device.
– Suited in particular for drive tasks with more demanding requirements/more
comprehensive parameter setting.
Tip!
• During operation, the keypad can be plugged anytime and removed again from
the controller.
• The drive controller can remain separated from the three-phase power supply
system if only parameter setting and diagnosis are to take place during
commissioning. In this case, it is sufficient to supply the drive controller from an
external direct-voltage source (U = 24 V).
• Use the drive diagnostic function of the "X400" keypad (if available) and the
LEDs located on the front of the drive controller:
DRIVE READY/ERROR: LED status displays of the device state
( 454)
CAN-RUN/CAN-ERR: LED status displays for the system bus
( 507)
Preconditions for commissioning with the »Engineer«
For commissioning, you need
a PC that satisfies the following requirements:
– processor with 1.4 GHz or higher
– at least 512 MB RAM and 650 MB free hard disc space
– Microsoft® Windows® 2000 operating system (from service pack 2 onwards) or
Windows® XP
the Lenze »Engineer« PC software
a connection to the drive controller
– for example via the X6/USB diagnostic adapter which serves as a diagnostic
interface.
The USB diagnostic adapter is not included in the scope of supply for the drive
controller. It must be appropriately connected to the X6 diagnostic interface ("DIAG"
terminal) of the drive controller and to a free USB port of the PC. The associated
description is contained on the CD accompanying the drive controller.
Tip!
You can find detailed information on the general use of the »Engineer« in the
online help which you can call with [F1].
If necessary, carry out a software update to bring the engineering software up-to-
date. You can find more information on this topic in the chapter entitled
"Introduction: Parameterising the controller
". ( 26)
efesotomasyon.com - Lenze
To Next Page
Loading...