Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 33
8400 HighLine | Parameter setting & configuration
Commissioning
Guide
3 Commissioning
3.1 Guide
Commissioning for test/demonstration purposes
This type of commissioning serves to make the motor rotate in best time for test/
demonstration purposes with as little wiring effort and optimisation as possible.
Commissioning is performed using the X400 keypad which includes a separate "Quick
commissioning" menu with all the parameters required for basic readiness for operation.
Quick commissioning
( 38)
Commissioning of technology applications
Commissioning the "Actuating drive speed" TA using the keypad
( 43)
Commissioning the "Actuating drive speed" TA using the »Engineer«
( 46)
Commissioning the "Table positioning" TA using the »Engineer«
( 50)
Commissioning the "Switch-off positioning" TA using »Engineer«
( 60)
3.1.1 Before commissioning
The »Engineer« and the X400 keypad are available as commissioning tools when a Lenze
drive controller has to be commissioned. The question as to which of these two
commissioning tools should be used for a particular instance of commissioning depends
on several factors and cannot be responded to with a globally applicable answer.
For a practiced user, for example, using the keypad during commissioning of a simple drive
task is often the easier method if the convenience and diagnostics options of the
»Engineer« are not needed. Frequently, the complexity of the machinery to be
commissioned determines which is the most suitable commissioning tool.
Some criteria may help you to select the right commissioning tool:
Commissioning using the X400 keypad is suitable
– for simple drive tasks such as quick commissioning for test/demonstration purposes
– and - to a limited degree - for commissioning the "Actuating drive speed" technology
application.
Danger!
Take all the necessary safety precautions before you carry out the following
commissioning steps and switch the device on!
Safety instructions with regard to commissioning
( 36)
efesotomasyon.com - Lenze
To Next Page
Loading...