8400 HighLine | Parameter setting & configuration
Technology applications
TA "Actuating drive speed"
262 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
7.4 TA "Actuating drive speed"
Features
Pre-configured control modes for terminals and bus control (with predefined process
data connection to the fieldbus)
Free configuration of input and output signals
Offset, gain, and negation of main setpoint, additional setpoint, actual process
controller value
Up to 15 fixed setpoints for speed and ramp time
Adjustable setpoint ramp times
Freely selectable, variable ramp shape
Automatic holding brake control
Quick stop (QSP) with adjustable ramp time
Motor potentiometer function
Process controller
Load monitoring (in preparation)
Integrated disposable "GeneralPurpose" functions:
Analog switch , arithmetic, multiplication/division, binary delay element, binary logic,
analog comparison, D-flipflop
Interface to the safety module (optional)
Integration of encoder feedback
Related topics:
Commissioning the "Actuating drive speed" TA using the keypad
( 43)
Commissioning the "Actuating drive speed" TA using the »Engineer« ( 46)
efesotomasyon.com - Lenze
To Next Page
Loading...