Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 217
8400 HighLine | Parameter setting & configuration
I/O terminals
Digital input terminals
6.1 Digital input terminals
The drive controller has 7 parameterisable input terminals (DI1 ... DI7) for detecting digital
signals. The RFR control input for enabling the controller is permanently connected to the
device control unit.
Parameterisation dialog in the »Engineer«:
Button Function
Indicates the polarity of the input is HIGH active.
The polarity can be changed from HIGH active to LOW active by clicking on this button.
Indicates that the polarity of the input is LOW active.
The polarity can be changed from LOW active to HIGH active by clicking on this button.
Open the parameterising dialog for assigning application inputs to the digital input.
Changing the terminal assignment with the »Engineer«
( 249)
efesotomasyon.com - Lenze
To Next Page
Loading...