8400 HighLine | Parameter setting & configuration
Motor control (MCTRL)
96 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
5 Motor control (MCTRL)
This chapter provides information on the parameter setting of the controller's internal
motor control.
Topics:
Motor selection/Motor data
Selecting the operating mode
Defining current and speed limits
V/f characteristic control (VFCplus)
V/f control (VFCplus + encoder)
Sensorless vector control (SLVC)
Servo control (SC)
Parameterisable additional functions
Encoder/feedback system
Braking operation/braking energy management
Monitoring
Internal interfaces | system block "LS_MotorInterface"
Internal status signals | system block "LS_DeviceMonitor"
efesotomasyon.com - Lenze
To Next Page
Loading...