Lenze E84AVHC Series - 9.6.2 Setting the error response

8400 HighLine | Parameter setting & configuration
Diagnostics & error management
Monitoring
466 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
9.6.2 Setting the error response
When a monitoring function responds, the response set for this monitoring function
(TroubleQSP, Warning, Fault, etc.) will be triggered.
 For many monitoring functions the response can be individually parameterised via
parameters.
 Tip!
The table in chapter "Short overview (A-Z)
" contains the error messages for which
the response can be set .
( 475)
Warning thresholds
Some of the monitoring functions are activated if a defined warning threshold (e.g.
temperature) has been exceeded.
 The corresponding preset threshold values can be changed via the following
parameters:
Parameter Info
C00120
Motor overload threshold (I²xt)
C00123
Device utilisat. threshold (Ixt)
C00572
Brake resistor overload threshold
C00599
Motor phase failure threshold
efesotomasyon.com - Lenze