8400 HighLine | Parameter setting & configuration
Parameter reference
Parameter list | C00705
696 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
C00705
C00706
C00710
C00701/41 0: Not connected LA_NCtrl
: bFreeIn1
C00701/42 0: Not connected LA_NCtrl
: bFreeIn2
C00701/43 0: Not connected LA_NCtrl
: bFreeIn3
C00701/44 0: Not connected LA_NCtrl
: bFreeIn4
C00701/45 0: Not connected LA_NCtrl
: bFreeIn5
C00701/46 0: Not connected LA_NCtrl
: bFreeIn6
C00701/47 0: Not connected LA_NCtrl
: bFreeIn7
C00701/48 0: Not connected LA_NCtrl
: bFreeIn8
; Read access ; Write access CINH PLC STOP No transfer COM MOT Scaling factor: 1
Parameter | Name:
C00701 | LA_NCtrl: digital connection list
Data type: UNSIGNED_16
Index: 23874
d
= 5D42
h
Parameter | Name:
C00705 | LA_NCtrl_Out: analog signal list
Data type: UNSIGNED_16
Index: 23870
d
= 5D3E
h
This code is for device-internal use only and must not be written to by the user!
Parameter | Name:
C00706 | LA_NCtrl_Out digital signal list
Data type: UNSIGNED_16
Index: 23869
d
= 5D3D
h
This code is for device-internal use only and must not be written to by the user!
Parameter | Name:
C00710 | LA_TabPos: Analog connection list
Data type: UNSIGNED_16
Index: 23865
d
= 5D39
h
Connection parameters for "Table positioning" application: 16-bit inputs
• Selection of the 16-bit output signals for connection with the 16-bit input signals
• The selection list contains all 16-bit output signals which can be assigned to the 16-bit inputs mapped by the
subcodes.
Selection list
See selection list - analog signals
Subcodes Lenze setting Info
C00710/1 0: Not connected LA_TabPos
: wCanDriveControl
(input for control word from CAN to device control)
C00710/2 0: Not connected LA_TabPos
: wMciDriveControl
(input for control word from communication interface to
device control)
C00710/3 0: Not connected LA_TabPos
: nTorqueMotLim_a
(input for maximum torque in motor mode)
C00710/4 0: Not connected LA_TabPos
: nTorqueGenLim_a
(input for maximum torque in generator mode)
C00710/5 0: Not connected LA_TabPos
: nMainSetValue_a
(input for main speed setpoint)
C00710/6 0: Not connected LA_TabPos
: nAuxSetValue_a
(input for additional speed setpoint)
C00710/7 0: Not connected LA_TabPos
: wMckCtrl1
(input for MCK control word 1)
C00710/8 0: Not connected LA_TabPos
: wMckCtrl2
(input for MCK control word 2)
C00710/9 0: Not connected LA_TabPos
: wMckOperationMode
(input for selection of MCK operating mode)
C00710/10 0: Not connected LA_TabPos
: wPosProfileMode
(input for selection of MCK positioning mode in
positioning mode)
efesotomasyon.com - Lenze
To Next Page
Loading...