EasyManua.ls Logo

Lenze E84AVHC Series - 14.2 System blocks

Lenze E84AVHC Series
1118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8400 HighLine | Parameter setting & configuration
Function library
System blocks
1070 L Firmware 05.00 - DMS 4.2 EN - 02/2010
14.2 System blocks
This chapter describes the system blocks which are available for the controller in the FB
Editor.
Overview of system blocks available
The function blocks are described in the chapter "Function blocks". ( 872)
System block Function
can be inserted into
level:
I/O Applicatio
n
LS_AnalogInput Interface to the analog input terminals
Analog terminals
( 234)
z
LS_AnalogOutput
Interface to the analog output terminals
Analog terminals
( 234)
z
LS_CANManagement
Control of internal functions of the CAN driver and display of the
"Operational" state as well as the node address
System bus "CAN on board"
( 500)
z
LS_DataAccess Lenze internal only z
LS_DeviceMonitor
Motor control status signals
Motor control (MCTRL)
( 96)
z
LS_DigitalInput
Interface to the digital input terminals
Digital input terminals
( 217)
z
LS_DigitalOutput
Interface to the digital output terminals
Digital output terminals
( 231)
z
LS_DisFree
Display of 8 arbitrary 16-bit signals of the application on display
codes
zz
LS_DisFree_a
Display of 8 arbitrary analog signals of the application on display
codes
zz
LS_DisFree_b
Display of 16 arbitrary digital signals of the application on a bit
coded display code
zz
LS_DisFree_p
Display of 8 arbitrary position signals of the application on
display codes
zz
LS_DriveInterface
Interface for drive control (DCTRL)
Device control (DCTRL)
( 65)
z
LS_Keypad Keypad control z
LS_MotionControlKernel
Interface to the basic drive function implemented in the Motion
Control Kernel (MCK)
Basic drive functions (MCK)
( 361)
z
LS_MotorInterface
Interface to the motor control (MCTRL)
Motor control (MCTRL)
( 96)
z
LS_ParFix
Output of frequently used constants (TRUE, FALSE, 100 %, etc.) to
be used in the interconnection
z
LS_ParFree
Output of 32 parameterisable 16-bit signals z
LS_ParFree_a Output of 16 parameterisable analog signals z
LS_ParFree_b
Output of 32 parameterisable digital signals z
LS_ParFree_p
Output of 8 parameterisable position signals z
LS_ParFree_v
Output of 8 parameterisable speed signals z
efesotomasyon.com - Lenze

Table of Contents

Related product manuals