Lenze E84AVHC Series - C00231 | L_PCTRL_1: Operating range; C00233 | L_PCTRL_1: Root function; C00234 | Oscillation damping influence; C00235 | Filter time - oscill. damping

8400 HighLine | Parameter setting & configuration
Parameter reference
Parameter list | C00231
630 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
C00231
C00233
C00234
C00235
C00236
Parameter | Name:
C00231 | L_PCTRL_1: Operating range
Data type: INTEGER_16
Index: 24344
d
= 5F18
h
FB L_PCTRL_1: Operating range for the PID process controller
Setting range (min. value | unit | max. value)
0.00 % 199.99
Subcodes Lenze setting Info
C00231/1 199.99 % L_PCTRL_1
: Pos. maximum
C00231/2 0.00 % L_PCTRL_1
: Pos. minimum
C00231/3 0.00 % L_PCTRL_1
: Neg. minimum
C00231/4 199.99 % L_PCTRL_1
: Neg. maximum
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00233 | L_PCTRL_1: Root function
Data type: UNSIGNED_8
Index: 24342
d
= 5F16
h
FB L_PCTRL_1: Use of the root function at the actual value input
Selection list (Lenze setting printed in bold) Info
0Off Root function inactive
• The actual value nAct_a is not changed for further
processing.
1 On Root function active
• The square root of the actual value nAct_a is taken for
further processing.
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00234 | Oscillation damping influence
Data type: UNSIGNED_16
Index: 24341
d
= 5F15
h
Oscillation damping
Setting range (min. value | unit | max. value) Lenze setting
0.00 % 250.00 5.00 %
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00235 | Filter time - oscill. damping
Data type: UNSIGNED_8
Index: 24340
d
= 5F14
h
Oscillation damping
Setting range (min. value | unit | max. value) Lenze setting
2 ms 250 32 ms
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00236 | Oscill. damping - field weaken.
Data type: UNSIGNED_8
Index: 24339
d
= 5F13
h
Oscillation damping for idling machines
Oscillation damping
Setting range (min. value | unit | max. value) Lenze setting
04014
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
efesotomasyon.com - Lenze