8400 HighLine | Parameter setting & configuration
Fieldbus interface
572 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
11 Fieldbus interface
The drive controllers of the 8400 series can accommodate plug-in communication modules
and can therefore take part in the data transfer of an existing fieldbus system.
When using a communication module, the major advantage for the user is the possibility
of parameterising, controlling, and diagnosing the drive system via the available fieldbus.
The following fieldbuses are supported by the 8400 drive controller:
PROFIBUS DPV1 - slave
Ethernet non-real-time
– ProfiNet IO V2 (in preparation)
– Powerlink BasicMode (in preparation)
Ethernet real-time
– Ethernet POWERLINK (in preparation)
– EtherCat (in preparation)
efesotomasyon.com - Lenze
To Next Page
Loading...