Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 393
8400 HighLine | Parameter setting & configuration
Basic drive functions (MCK)
Speed follower
8.5 Speed follower
In the "speed follower" operating mode, the drive follows a speed setpoint.
8.5.1 Parameter setting
Short overview of parameters for the "speed follower" operating mode:
8.5.1.1 Functional settings
In C01219
, various functional settings for the speed follower can be made in bit-coded
form.
HW limit switch on
If this function has been activated by means of bit 2 in C01219
, travel range monitoring by
means of hardware limit switches is active in the operating mode.
Limit position monitoring
( 389)
SW limit switch on
If this function has been activated by means of bit 3 in C01219
, travel range monitoring by
means of parameterised software limit positions is active in this operating mode.
Limit position monitoring
( 389)
Position controller off
If this function is activated via bit 7 in C01219
, the position controller is deactivated in this
operating mode. Hence, following error control is switched-off.
Parameter Info Lenze setting
Value Unit
C01219 MCK: Speed follower setting Bit coded
C02610/2
MCK: Setpoint - ramp time synchronisation 2.000 s
C02611/1
MCK: Pos. max. speed 199.99 %
C02611/2
MCK: Pos. min. speed 0.00 %
C02611/3
MCK: Neg. min. speed 0.00 %
C02611/4
MCK: Neg. max. speed 199.99 %
Function Lenze setting
Bit 0 Reserved Off
Bit 1 Reserved Off
Bit 2 HW limit switch on On
Bit 3 SW limit switch on On
Bit 4 Reserved Off
Bit 5 Reserved Off
Bit 6 Reserved Off
Bit 7 Position controller off Off
efesotomasyon.com - Lenze
To Next Page
Loading...