8400 HighLine | Parameter setting & configuration
Basic drive functions (MCK)
Manual jog
406 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
8.7 Manual jog
In this operating mode, the drive can be traversed manually in a clockwise or anticlockwise
direction ("jogging mode").
As an option, it is possible to change over to a second speed during traversing.
"Retraction" of operated (travel range) limit switches is also supported. Only traversing
in the corresponding retracting direction is then possible.
Danger!
During manual jogging, specially assigned profile parameters are active. If they
have not been set correctly, the drive can engage in uncontrolled movement!
Stop!
In the Lenze setting, travel range monitoring is switched-off in C01230 by means
of hardware limit switches and software limit positions for the "Manual jog"
operating mode!
If travel range monitoring has been deactivated, the drive can travel into a
mechanical limit during manual jogging and machine parts can be destroyed or
damaged!
efesotomasyon.com - Lenze
To Next Page
Loading...