Lenze E84AVHC Series - C01203 | Axis data: iG motor;pos. encoder; C01204 | Axis data: Feed constant; C01205 | Axis data: Position resolution; C01206 | Axis data: Mounting direction

Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 767
8400 HighLine | Parameter setting & configuration
Parameter reference
Parameter list | C01203
C01203
C01204
C01205
C01206
Parameter | Name:
C01203 | Axis data: iG motor/pos. encoder
Data type: UNSIGNED_16
Index: 23372
d
= 5B4C
h
Gearbox factor - position encoder
• Entry of the gearbox factor as numerator/denominator ratio, with numerator = motor speed and denominator
= position encoder speed.
Machine parameter
Setting range (min. value | unit | max. value)
1 65535
Subcodes Lenze setting Info
C01203/1 1 iG: Numerator (motor speed)
C01203/2 1 iG: Denominator (encoder speed)
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C01204 | Axis data: Feed constant
Data type: INTEGER_32
Index: 23371
d
= 5B4B
h
The feed constant corresponds to the machine movement for one revolution of the gearbox output shaft.
• The value is entered in application units referred to one revolution.
Machine parameter
Setting range (min. value | unit | max. value) Lenze setting
0.0001 units/rev. 214748.3647 360.0000 units/rev.
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10000
Parameter | Name:
C01205 | Axis data: Position resolution
Data type: INTEGER_32
Index: 23370
d
= 5B4A
h
Display of the number of increments corresponding to one unit.
• 1 motor revolution ≡ 65536 increments
Machine parameter
Display range (min. value | unit | max. value)
0.0000 incr/unit 214748.3647
; Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10000
Parameter | Name:
C01206 | Axis data: Mounting direction
Data type: UNSIGNED_8
Index: 23369
d
= 5B49
h
Inversion for mirrored motor and encoder mounting
Machine parameter
Selection list
0not inverted
1inverted
Subcodes Lenze setting Info
C01206/1 0: Not inverted Motor mounting direction
• Setting for motor mounting turned by 180°.
C01206/2 0: Not inverted Position encoder mounting direction
• Setting for position encoder system mounting turned
by 180°.
; Read access ; Write access ; CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
efesotomasyon.com - Lenze