Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 97
8400 HighLine | Parameter setting & configuration
Motor control (MCTRL)
Motor selection/Motor data
5.1 Motor selection/Motor data
The motor data term comprises all parameters that only depend on the motor and that
only characterise the electrical behaviour of the machine. The motor data are independent
of the application in which the controller and the motor are used.
Proceed as follows to open the dialog for parameterising the motor data:
1. In the »Engineer«, go to the Project view and select the 8400 HighLine C controller.
2. Go to Workspace and change to the Application parameters tab.
3. Go to the Overview dialog level and click the following button:
Parameterisation dialog in the »Engineer«
Via the From motor catalogue ... button, the motor catalogue can be opened to select
another motor.
Selecting a motor from the motor catalogue in the »Engineer« ( 100)
Via the From drive... button, the motor data set in the controller can be copied to the
»Engineer« when an online connection has been established.
Via the Identification in progress... button, various motor data can be identified
automatically when an online connection to the controller has been established.
Automatic motor data identification
( 102)
If applicable, go to the settings of the encoder/feedback system via the Encoder/
Feedback system... button. Encoder/feedback system
( 182)
efesotomasyon.com - Lenze
To Next Page
Loading...