Lenze E84AVHC Series - 2 Introduction: Parameterising the controller

8400 HighLine | Parameter setting & configuration
Introduction: Parameterising the controller
26 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
2 Introduction: Parameterising the controller
[2-1] Exemplary constellation for parameterising the controller
Being a component of a machine which includes a speed-variable drive system, the
controller needs to be adjusted to its drive task. The controller is adjusted by changing
parameters which are saved in the memory module.
These parameters can optionally be accessed from the keypad, or the L-force »Engineer«,
or a master control via fieldbus communication:
 Simply plug in the X400 keypad onto the controller if you would like to use it.
 The USB diagnostic adapter, for instance, can be used for the communication between
the PC (including the L-force »Engineer« software) and the controller, see illustration.
The USB diagnostic adapter is the connection between the PC (free USB port) and the
controller (X6 diagnostic interface).
 The "CAN on board" CAN interface and the MCI interface are provided for fieldbus
communication and can be used for a communication module (e.g. PROFIBUS).
 Tip!
How to obtain/update the L-force »Engineer« software:
• Download from the Internet:
The full version of the »Engineer StateLevel« is provided free of charge. Current
software can be found on the Internet in the "Services & Downloads" area under
http://www.Lenze.com
.
• Requesting the CD
You can also request the L-force »Engineer« separately on CD free of charge at
your Lenze representative. See the "About Lenze" area on our homepage for e.g.
the corresponding German address.
efesotomasyon.com - Lenze