Lenze E84AVHC Series - 8.3.1.1 Alternative functions for control bit PosExecute

Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 381
8400 HighLine | Parameter setting & configuration
Basic drive functions (MCK)
MCKInterface
8.3.1.1 Alternative functions for control bit "PosExecute"
In C01297
, alternative functions for bit 16 (PosExecute) in the MCK control word can be
selected with bit-coding.
PosStop with PosExecute = FALSE
If bit 0 has been set in C01297
, positioning can only be started/cancelled with the
"PosExecute" control bit.
 If the "Positioning" operating mode has been set on the MCK, the "Pos-Execute" control
bit has the following effects when being activated:
HomingStartStop with PosExecute
If bit 1 has been set in C01297
, homing can only be started/stopped with the "PosExecute"
control bit.
 If the "positioning" operating mode has been set on the MCK, the "PosExecute" control
bit has the following effect when activated:
SetProfilPosition with PosExecute
If bit 2 has been set in C01297
and control bit ("PosExecute") is being set, the setpoint
position being applied is incorporated in the currently selected profile and then the profile
is started immediately.
 If the "positioning" operating mode has been set on the MCK, the "PosExecute" control
bit has the following effect when activated:
Signals at the input Signals in the control word to the MCK
bPosExecute = TRUE bPosExecute = TRUE
bPosStop = FALSE
bHomingStartStop remains unchanged
bPosExecute = FALSE bPosExecute = FALSE
bPosStop = TRUE
bHomingStartStop remains unchanged
Signals at the input Signals in the control word to the MCK
bPosExecute = TRUE bPosExecute = TRUE
bPosStop = FALSE
bHomingStartStop = TRUE
bPosExecute = FALSE bPosExecute = FALSE
bPosStop remains unchanged
bHomingStartStop = FALSE
Signals at the input Signals in the control word to the MCK
bPosExecute = TRUE bPosExecute = TRUE
bPosStop = FALSE
bHomingStartStop remains unchanged
bPosTeachSetPos = TRUE (edge)
bPosExecute = FALSE bPosExecute = FALSE
bPosStop remains unchanged
bHomingStartStop remains unchanged
bPosTeachSetPos = FALSE
efesotomasyon.com - Lenze