8400 HighLine | Parameter setting & configuration
Basic drive functions (MCK)
Manual jog
408 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
8.7.1.1 Functional settings
In C01230
, various functional settings for manual jogging can be carried out in bit-coded
form.
Manual jog with breakpoint
If this function has been activated by means of bit 0 in C01230
, a stop during manual
jogging is automatically made at the breakpoint positions set in C01234/1...4
.
The home position must be known for this function.
Travelling is continued when the pushbutton is "released" and pressed again. This
button has been assigned the ManJogPos and/or ManJogNeg control function.
Manual jog with automatic changeover to speed 2
If this function has been activated by means of bit 1 in C01230
and the waiting time set in
C01235/1
has expired, an automatic changeover to manual jog speed 2 (C01231/2) takes
place.
By leaving the corresponding button for manual jog pressed down for longer than the
waiting time and parameterising manual jog speed 2 so that it is higher than manual jog
speed 1, you can enable longer distances to be travelled by means of manual jogging with
this function.
HW limit switch on
If this function has been activated by means of bit 2 in C01230
, travel range monitoring by
means of hardware limit switches is active in this mode.
Limit position monitoring
( 389)
SW limit switch on
If this function has been activated by means of bit 3 in C01230
, travel range monitoring by
means of parameterised software limit positions is active in this mode.
Limit position monitoring
( 389)
Position controller off
If this function is activated via bit 7 in C01230
, the position controller is deactivated in this
operating mode. Hence, following error control is switched-off.
Function Lenze setting
Bit 0 Manual jog with breakpoint Off
Bit 1 Manual jog with automatic changeover to speed 2 Off
Bit 2 HW limit switch on Off
Bit 3 SW limit switch on Off
Bit 4 Reserved Off
Bit 5 Reserved Off
Bit 6 Reserved Off
Bit 7 Position controller off Off
efesotomasyon.com - Lenze
To Next Page
Loading...