EasyManua.ls Logo

Lenze E84AVHC Series - 4.5.2 wDeviceStatusWord status word

Lenze E84AVHC Series
1118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Firmware 05.00 - DMS 4.2 EN - 02/2010 L 95
8400 HighLine | Parameter setting & configuration
Device control (DCTRL)
Internal interfaces | "LS_DriveInterface" system block
4.5.2 wDeviceStatusWord status word
The wDeviceStatusWord status word provided by the control system contains all
information relevant for controlling the controller.
The status word is sent as a process data word to the master control via a port block:
–The LP_CanOut1 port block if "CAN on board" is used or
–the LP_MciOut1 port block if a plugged-in communication module is used (e.g.
PROFIBUS).
Display parameter: C00150
The bit assignment of the wDeviceStatusWord status word can be seen from the table
below.
Bit 14 SetFail 1 Set error (trip set)
Bit 15 LenzeSpecific_4 Assignment depends on the selected technology application
See description of the corresponding technology application.
Bit Name Function
Bit Name Status
Bit 0 FreeStatusBit0 Free status bit 0
Bit 1 PowerDisabled 1 Inverter control inhibited (pulse inhibit is active)
Bit 2 FreeStatusBit2 Free status bit 2 (not assigned, freely assignable)
Bit 3 FreeStatusBit3 Free status bit 3 (not assigned, freely assignable)
Bit 4 FreeStatusBit4 Free status bit 4 (not assigned, freely assignable)
Bit 5 FreeStatusBit5 Free status bit 5 (not assigned, freely assignable)
Bit 6 ActSpeedIsZero During open-loop operation:
1 Speed setpoint < Comparison value (C00024
)
During closed-loop operation:
1 Actual speed value < Comparison value (C00024
)
Bit 7 ControllerInhibit 1 Controller inhibited (controller inhibit is active)
Bit 8 StatusCodeBit0 Bit coded display of the active device state
Device states
(see table [4-1])
Bit 9 StatusCodeBit1
Bit 10 StatusCodeBit2
Bit 11 StatusCodeBit3
Bit 12 Warning 1 Controller is in the "Warning
" device state
Bit 13 Trouble 1 Controller is in the "Trouble
" device state
E.g. if an overvoltage has occurred.
Bit 14 FreeStatusBit14 Free status bit 14 (not assigned, freely assignable)
Bit 15 FreeStatusBit15 Free status bit 15 (not assigned, freely assignable)
efesotomasyon.com - Lenze

Table of Contents

Related product manuals