8400 HighLine | Parameter setting & configuration
Parameter reference
578 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
12 Parameter reference
This chapter describes all parameters which can be used for parameterising and
monitoring the controller.
Parameters which are only available in the controller from a certain software version
onwards are marked with a corresponding note in the parameter description ("from
version xx.xx.xx").
The parameter descriptions are based on software version V05.00.00
Tip!
For quick reference of a parameter with a certain name, simply use the index of the
online documentation. The index always contains the corresponding code in
parentheses after the name.
General information on parameter setting can be found in the "Introduction:
Parameterising the controller" chapter. ( 26)
For general information on how to read and change parameters, please see the
online documentation for the »Engineer«.
efesotomasyon.com - Lenze
To Next Page
Loading...