Lenze E84AVHC Series User Manual

8400 HighLine | Parameter setting & configuration
Function library
Function blocks | L_Odometer_1
1010 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
14.1.99 L_Odometer_1
This FB is used to detect positions and calculate distances.
 Depending on the input selection set in C01022
, a position signal can be detected at the
dnInPosition_p input or a speed can be detected at the nInSpeed_v input.
 The position is detected/accepted via the edge selected in C01023
at the bTriggerPulse
input.
 If "Ring buffer" is selected in C01021
, the measurement will start all over again after
the number of measurements selected in C01020
has been performed and the old
values will be overwritten. Otherwise, the measurement will stop.
Inputs
Identifier
Data type
Information/possible settings
dnInPosition_p
DINT
Position measurement input
• Input is only evaluated if C01022
= "0: Pos input" has been set.
nInSpeed_v
INT
Speed measurement input
• The speed is internally integrated into a position.
• Input is only evaluated if C01022
= "1: V input" has been set.
bTriggerPulse
BOOL
Detect position/speed
• The tripping edge can be parameterised in C01023
.
bReset
BOOL
Reset measurement results and internal integrator
TRUE Reset measurement results and internal integrator.
/B2GRPHWHUB
GQ,Q3RVLWLRQBS
GQ,Q6SHHGBY
E7ULJJHU3XOVH
E5HVHW
& 0HPRU\GHSWK
&
0HPRU\W\SH
&
,QSXW6HOHFWLRQ
&
(GJHVHOHFWLRQ
GQ3RV2XWBBS
GQ3RV2XWBBS
GQ3RV2XWBBS
GQ3RV2XWBBS
GQ3RV2XWBBS
GQ3RV2XWBBS
GQ3RV2XWBBS
GQ3RV2XWBBS
GQ'HOWD3RVBBS
GQ'HOWD3RVBBS
GQ'HOWD3RVBBS
GQ'HOWD3RVBBS
GQ'HOWD3RVBBS
GQ'HOWD3RVBBS
GQ'HOWD3RVBBS
GQ'HOWD3RVBBS
Z/DVW0HDVXUH
3RV
3RV
3RV
3RV
3RV
3RV
efesotomasyon.com - Lenze

Lenze E84AVHC Series Specifications

General

Brand	Lenze
Model	E84AVHC Series
Category	Inverter Drive
Language	English