Lenze E84AVHC Series - 10.1.3 Communication time

8400 HighLine | Parameter setting & configuration
System bus "CAN on board"
General information
504 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
10.1.3 Communication time
The communication time is the time between the start of a request and the arrival of the
corresponding response.
 Tip!
The communication times in the CAN network depend on:
• the processing time in the device
• the telegram runtime (baud rate/telegram length)
• the bus load (especially if the bus is charged with PDOs and SDOs at a low baud
rate)
Processing time in the 8400 controller
No dependencies exist between parameter data and process data.
 Parameter data: approx. 5 ms (typical value)
– For parameters concerning the motor control (e.g. C00011), the processing time may
be longer (up to 30 ms).
 Process data: 1 ms
efesotomasyon.com - Lenze