Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 337
8400 HighLine | Parameter setting & configuration
Technology applications
TA "Switch-off positioning"
7.6.3 Terminal assignment of the control modes
The following comparison provides information about which inputs/outputs of the application block LA_SwitchPos are
interconnected to the digital and analog input/output terminals of the drive controller in the different control modes.
Control mode(C00007)
10: Terminals 0 12: Terminals 2 14: Terminals 11 16: Terminal 16 20: Keypad 21: PC 30: CAN 40: MCI
Digital input terminals
X5/RFR - Controller enable/reset error
bFailReset
X5/DI1 Fixed setpoint 1
bJogCtrlJog1
Stop function 1
bJogCtrlStop1
Fixed setpoint 1
bJogCtrlJog1
- - Stop function 1
bJogCtrlStop1
X5/DI2 Fixed setpoint 2
bJogCtrlJog2
Stop function 2
bJogCtrlStop2
Selection: Pre-switch off
1
bJogCtrlSlowDown 1
Fixed setpoint 2
bJogCtrlJog2
Selection: Pre-switch off 1
bJogCtrlSlowDown 1
X5/DI3 Controller enable
bFailReset
CW rotation quick stop
bRLQCw
Selection: Switch-off position 1
bJogCtrlInputSel1
CW rotation quick stop
bRLQCw
Stop function 2
bJogCtrlStop2
X5/DI4 Change of direction of
rotation
bSetSpeedCcw
CCW rotation quick stop
bRLQCcw
Selection: Switch-off position 2
bJogCtrlInputSel2
CCW rotation quick stop
bRLQCcw
Selection: Pre-switch off 2
bJogCtrlSlowDown 2
X5/DI5
- - Stop function 2
bJogCtrlStop2
- Stop function 3
bJogCtrlStop3
X5/DI6
- - Selection: Pre-switch off
2
bJogCtrlSlowDown 2
- Selection: Pre-switch off 3
bJogCtrlSlowDown 3
X5/DI7
- - - - - -
Analog input terminals
X3/A1U, A1I Main speed setpoint
nMainSetValue_a
10V ≡ 100% of reference speed (C00011
)
- - Additional speed setpoint
nAuxSetValue_a
10V ≡ 100% of reference speed (C00011
)
X3/A2U, A2I
- - - - - - - -
Digital output terminals
X4/DO1 ... DO3 - - - - - - - -
X107/BD1 Brake released
bMBrakeReleaseOut
X107/BD2 Brake feedback
X101/NO
- - - - - - - -
Analog output terminals
X3/O1U, O1I - - - - - - - -
X3/O2U, O2I
efesotomasyon.com - Lenze
To Next Page
Loading...