Lenze E84AVHC Series - Ck05: Following error 1 [xx.0184.00153]; Ck06: Following error 2 [xx.0184.00154]; Ck07: Travel range limit exceeded [xx.0184.00155]; Ck08: Home position unknown [xx.0184.00156]

8400 HighLine | Parameter setting & configuration
Diagnostics & error management
Error messages of the operating system
492 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
Ck05: Following error 1 [xx.0184.00153]
Ck06: Following error 2 [xx.0184.00154]
Ck07: Travel range limit exceeded [xx.0184.00155]
Ck08: Home position unknown [xx.0184.00156]
Ck09: Positioning mode invalid [xx.0184.08005]
Ck10: Implausible profile data [xx.0184.08007]
Response (Lenze setting printed in bold) Setting: C00595/5 (; Adjustable response)
; None ; Fault  Trouble ; TroubleQuickstop : Warning ; WarningLocked ; Information
Cause Remedy
MCK: Following error limit 1 (C01215/1) has been
exceeded.
• Optimise control mode.
• Increase following error limit.
• Deactivate following error monitoring.
Response (Lenze setting printed in bold) Setting: C00595/6 (; Adjustable response)
; None ; Fault  Trouble ; TroubleQuickstop : Warning ; WarningLocked ; Information
Cause Remedy
MCK: Following error limit 2 (C01215/2) has been
exceeded.
• Optimise control mode.
• Increase following error limit.
• Deactivate following error monitoring.
Response (Lenze setting printed in bold) Setting: C00595/7 (; Adjustable response)
; None ; Fault  Trouble : TroubleQuickstop ; Warning ; WarningLocked ; Information
Cause Remedy
MCK: The maximum travel distance has been exceeded.
• The maximum travel distance is displayed in C01213/
1.
• Check profile parameters.
• Deactivate travel range limit monitoring.
Response (Lenze setting printed in bold) Setting: C00595/8 (; Adjustable response)
; None ; Fault  Trouble ; TroubleQuickstop ; Warning : WarningLocked ; Information
Cause Remedy
MCK: Home position is unknown. Perform homing.
Response (Lenze setting printed in bold) Setting: C00595/9 (; Adjustable response)
; None ; Fault  Trouble ; TroubleQuickstop ; Warning : WarningLocked ; Information
Cause Remedy
MCK: The positioning mode defined via the
wPosProfileMode input is not supported.
Define a valid positioning mode.
Response (Lenze setting printed in bold) Setting: C00595/10 (; Adjustable response)
; None ; Fault  Trouble ; TroubleQuickstop ; Warning : WarningLocked ; Information
Cause Remedy
MCK: Implausible profile data are at hand. Check profile data set.
efesotomasyon.com - Lenze