Lenze E84AVHC Series - C00638 | L_NSet_1: Ramp rounding output; C00639 | L_NSet_1: Addit. value output; C00640 | L_NSet_1: nNOut_a; C00650 | L_Arithmetik 3-5: Function

8400 HighLine | Parameter setting & configuration
Parameter reference
Parameter list | C00638
686 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
C00638
C00639
C00640
C00650
Parameter | Name:
C00638 | L_NSet_1: Ramp rounding output
Data type: INTEGER_16
Index: 23937
d
= 5D81
h
FB L_NSet_1: Display of the speed setpoint after PT1 filter function processing
Display range (min. value | unit | max. value)
-199.99 % 199.99
; Read access  Write access  CINH  PLC STOP ; No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00639 | L_NSet_1: Addit. value output
Data type: INTEGER_16
Index: 23936
d
= 5D80
h
FB L_NSet_1: Display of the additional speed setpoint after ramp generator processing
Display range (min. value | unit | max. value)
-199.99 % 199.99
; Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00640 | L_NSet_1: nNOut_a
Data type: INTEGER_16
Index: 23935
d
= 5D7F
h
FB L_NSet_1: Display of the generated main speed setpoint at the output nNOut_a
Display range (min. value | unit | max. value)
-199.99 % 199.99
; Read access  Write access  CINH  PLC STOP ; No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00650 | L_Arithmetik 3-5: Function
Data type: UNSIGNED_8
Index: 23925
d
= 5D75
h
Selection of the internal arithmetics
Selection list
0 nOut_a = nIn1_a
1 nOut_a = nIn1_a + nIn2_a
2 nOut_a = nIn1_a - nIn2_a
3 nOut_a = (nIn1_a * nIn2_a) / 100%
4 nOut_a = (nIn1_a * 1%) / |nIn2_a|
5 nOut_a = (nIn1_a * 100%) / (100% -
nIn2_a)
Subcodes Lenze setting Info
C00650/1 0: nOut_a = nIn1_a L_Arithmetik_3
: Function
C00650/2 0: nOut_a = nIn1_a L_Arithmetik_4
: Function
C00650/3 0: nOut_a = nIn1_a L_Arithmetik_5
: Function
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
efesotomasyon.com - Lenze