Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 853
8400 HighLine | Parameter setting & configuration
Working with the FB Editor
Reconfiguring the predefined interconnection
13.4.4 Creating/deleting connections
After adding objects and arranging them in a reasonable manner within the drawing area,
you can create the connections between the available objects which are required for the
desired function.
A connection always has a direction and therefore always has a source and a target.
Permissible/impermissible connections
Several connections can lead from one output.
However, maximally one connection may end in an input.
Only inputs/outputs of the same signal type can be connected.
An output represents a possible source
in the interconnection.
An input represents a possible target in
the interconnection.
Therefore it is always possible to start a
new connection from an output.
Therefore it is only possible to start a
new connection from an input if there
is no connection already ending in this
input.
Thus, a connection between different
port symbol cannot be established.
/B25B
E,Q
E,Q
E2XW
/B5/4B
E&Z
E&FZ
E4VS
E&Z&FZ
/B5/4B
E&Z
E&FZ
E4VS
E&Z&FZ
/B25B
E,Q
E,Q
E2XW
/B5/4B
E&Z
E&FZ
E4VS
E&Z&FZ
/B25B
E,Q
E,Q
E2XW
/B'7B
Q,QBD
Q2XWBD
/B25B
E,Q
E,Q
E2XW
efesotomasyon.com - Lenze
To Next Page
Loading...
Need help?
General
