Lenze E84AVHC Series User Manual

Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 21
8400 HighLine | Parameter setting & configuration
About this documentation
Document history
1 About this documentation
This Software Manual contains information on the parameterisation of the
8400 HighLine C controller by means of the L-force »Engineer« and the X400 keypad.
The information in this Software Manual is valid for the 8400 HighLine C controller with
the following nameplate data:
 Tip!
Current documentation and software updates for Lenze products can be found on
the Internet in the "Services & Downloads" area under
http://www.Lenze.com
1.1 Document history
 Danger!
The controller is a source of danger which may lead to death or severe injury of
persons.
To protect yourself and others against these dangers, observe the safety
instructions before switching on the controller.
Please read the safety instructions provided in the 8400 Mounting Instructions
and in the 8400 Hardware Manual 8400. Both documents are supplied with the
controller.
Product series Type designation From software version
8400 HighLine C E84AVHCxxxxx 01.00
Version Description
1.0 07/2008 TD06 First edition
2.0 11/2008 TD06 Extended by new functions for 8400 HighLine C V02.00.00
3.0 04/2009 TD06 Error corrections & supplements
3.1 08/2009 TD05/06 Extended by new functions for 8400 HighLine C V04.00.00
4.0 10/2009 TD05/06 Restructuring of some chapters, error corrections & supplements
4.1 12/2009 TD05 Error correction & amendments, parameter reference V05.00.00
4.2 02/2010 TD05 Error corrections & supplements
efesotomasyon.com - Lenze

Lenze E84AVHC Series Specifications

General

Brand	Lenze
Model	E84AVHC Series
Category	Inverter Drive
Language	English