Lenze E84AVHC Series - Page 32

8400 HighLine | Parameter setting & configuration
Introduction: Parameterising the controller
Handling the keypad
32 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
Menu structure
In the keypad, the parameters are classified into various menus and submenus.
 The USER menu includes a selection of frequently used parameters (freely configurable
in C00517
).
 The Code list contains all parameters.
 The Go to param function enables you to reach the corresponding parameter directly.
 The Logbook logs all errors and their chronological history.
 All other menus and submenus in the keypad correspond precisely to the categories
and subcategories which are displayed in the form of buttons on the left hand side of
the All parameters tab in the »Engineer«:
[2-2] All parameters tab in the »Engineer«
General operation
1. Use the
/ navigation keys to select the desired menu.
– Use the
/ navigation keys to reach a higher/lower menu level.
– Use the
 function key to return to the main menu.
2. Use the
/ navigation keys to select the parameter to be set within a submenu.
3. Use the
 function key to switch over to the editing mode.
4. Use the navigation keys to set the desired value.
– Use the
/ navigation keys to move the cursor to the left/right.
– Use the
/ navigation keys to change the selected digit.
5. Use the
 function key to accept the change and to leave the editing mode.
– Use the
 function key to leave the editing mode without accepting the change.
 Tip!
General information on setting parameters using the »Engineer« can be found in
the »Engineer« online help.
 Category
 Subcategories
efesotomasyon.com - Lenze