8400 HighLine | Parameter setting & configuration
Introduction: Parameterising the controller
Handling the memory module
30 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
Parameter set transfer using the »Engineer«
When an online connection to the controller has been established, the following transfer
functions can directly be executed via the Toolbar or the Online menu using the L-force
»Engineer«:
Tip!
Detailed information on parameter set transfers using the »Engineer« can be
found in the »Engineer« online help.
Symbol Menu command Shortcut
Download parameter set <F5>
Upload parameter set <F7>
Save parameter set
efesotomasyon.com - Lenze
To Next Page
Loading...