8400 HighLine | Parameter setting & configuration
About this documentation
Terminology used
24 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
System block System blocks provide interfaces to basic functions and to the hardware of the
controller in the EB Editor of the »Engineer« (e.g. to the digital inputs).
USB diagnostic adapter The USB diagnostic adapter is used for the operation, parameterisation, and
diagnostics of the controller. Data are exchanged between the PC (USB
connection) and the controller (diagnostic interface on the front) via the
diagnostic adapter.
• Order designation: E94AZCUS
VFCplus Operating mode: V/f characteristic control ("Voltage Frequency Control")
Term Meaning
efesotomasyon.com - Lenze
To Next Page
Loading...