Lenze E84AVHC Series - Page 248

8400 HighLine | Parameter setting & configuration
I/O terminals
User-defined terminal assignment
248 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
Configuration parameters for the inputs of the technology application
The following parameters can be used to change the preconfigured assignment of the
application inputs:
Example
Task:
Starting from the preset technology application "Actuating drive speed" and the
"Terminals 0" control mode, the DI2 digital input is to be used for choosing an alternative
acceleration/deceleration time for the main setpoint instead of for choosing the fixed
setpoint 2/3. To do this, the DI2 digital input is not to be linked to the bJogSpeed2 input but
to the bJogRamp1 input of the application module.
Procedure:
1. Use the keypad to navigate to the menu level Applications  Actuating drive speed
(conf.). This menu level contains all the configuration parameters of the technology
application "Actuating drive speed".
Configuration parameters (short overview)
( 289)
2. Navigate to the configuration parameter LA_NCtrl: bJogSpeed2 (C00701/10) which
represents the logical signal link of the application input bJogSpeed2.
3. Change the setting of C00701/10
:
Change selection "16001: DigIn_bIn2" in selection "0: Not interconnected".
4. Navigate to the configuration parameter LA_NCtrl: bJogRamp1 (C00701/13
) which
represents the logical signal link of the application input bJogRamp1.
5. Change the setting of C00701/13
:
Change selection "0: Not interconnected" in selection "16001: DigIn_bIn2".
 Tip!
The example shows that, for each input of the application block, the associated
configuration parameter (C00700/x
or C00701/x) is only allowed to contain one
source that you enter.
Parameter Info
TA "Actuating drive speed": Configuration parameters (short overview) ( 289)
C00700/1...18
Analog connection list
C00701/1...35
Digital connection list
TA "Table positioning": Configuration parameters (short overview) ( 322)
C00710/1...28
Analog connection list
C00711/1...56
Digital connection list
TA "Switch-off positioning": Configuration parameters (short overview) ( 353)
C00760/1...25
Analog connection list
C00761/1...47
Digital connection list
efesotomasyon.com - Lenze