8400 HighLine | Parameter setting & configuration
Introduction: Parameterising the controller
Handling the memory module
28 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
Delivery
All devices are delivered with a plugged-on memory module.
In the delivery state, the Lenze setting of the parameters is stored in the memory
module.
The memory module can be preconfigured with customer-specific data.
The memory module is available as a spare part - without any data.
During operation
Plugging and unplugging the memory module results in a message.
Full functionality of the memory module is even provided if the power supply has been
switched off and only the electronic components of the controller are externally
supplied by a 24 V DC voltage, e.g. via the X5/24E terminal.
Parameter sets can be saved manually.
Parameter sets can be loaded manually.
Note!
Automatic saving is explicitly not supported because this significantly reduces
the service life of the memory module.
efesotomasyon.com - Lenze
To Next Page
Loading...