Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 363
8400 HighLine | Parameter setting & configuration
Basic drive functions (MCK)
Basic signal flow
In the interconnection previously shown, the Motion Control Kernel monitors every
interface. Some of the signals such as a quick stop request or a DC-injection braking
request are directly passed through to the motor control. However, other signals are
passed through or modified depending on the operating mode (e.g. synchronising a
setpoint selection via ramp function).
efesotomasyon.com - Lenze
To Next Page
Loading...