Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 375
8400 HighLine | Parameter setting & configuration
Basic drive functions (MCK)
MCKInterface
Control of the Motion Control Kernel
Control of the basic drive functions implemented in the Motion Control Kernel is carried
out by means of
direct
specification of the control words, for example via a master control unit also
connected to the fieldbus.
– For this purpose, the control word inputs can be directly connected to the field bus
interface LP_MciIn respectively LP_CanIn.
– See the "MCK control word
" chapter for a detailed description of the individual
control bits.
the specification of individual process signals at the L_MckCtrlInterface
FB which are
then ORed with the control word.
Plausibility check
The process signals applied to the L_MckCtrlInterface
FB are logically linked by means of an
OR logic operation to the specified control word via the two control word inputs
wInMckPosCtrl_1 and wInMckPosCtrl_2 and, after a plausibility check, are output via the
two control word outputs wOutMckPosCtrl_1 and wOutMckPosCtrl_2 .
The profile number, the operating mode, and the positioning mode are checked for
plausibility.
If implausibility is detected, only control bit information is output and the bFail output
is set to TRUE.
The result of the plausibility check is provided as the wFailState output word and
displayed in C01299
.
The control words that are output, namely wOutMckPosCtrl_1 and wOutMckPosCtrl_2,
constitute the input information for the LS_MotionControlKernel
system block.
Status information of the Motion Control Kernel
Output by the LS_MotionControlKernel
, the status words wMotionState1 and
wMotionState2 also constitute input information for the
downstream L_MckStateInterface
FB, which provides this information to the application
in the form of process signals.
efesotomasyon.com - Lenze
To Next Page
Loading...