Lenze E84AVHC Series - Page 456

8400 HighLine | Parameter setting & configuration
Diagnostics & error management
Drive diagnostics with the »Engineer«
456 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
 How to diagnose a drive with the »Engineer«:
1. Go to the Project view and select the 8400 controller to be diagnosed.
2. Click the icon or execute the OnlineGo online command to establish an online
connection to the controller.
3. Select the Diagnostics tab.
• With an online connection, the Diagnostics tab displays current status
information about the controller.
 Tip!
The online connection to the controller can be established via the following device
interfaces:
• X1 CAN interface
Diagnostics via the System bus "CAN on board"
( 500)
• X6 diagnostic interface
We recommend this diagnostic connection when the X1 CAN interface is used
for process communication.
efesotomasyon.com - Lenze