8400 HighLine | Parameter setting & configuration
Parameter reference
Parameter list
586 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
C00002/15 0: Off / ready Reserved
C00002/16 1: On / start Enable controller
"1" ≡ Enable controller
"0" ≡ Inhibit controller
C00002/17 0: Off / ready Activate quick stop
"1" ≡ Activate quick stop
"0" ≡ Deactivate quick stop
C00002/18 0: Off / ready Reserved
C00002/19 0: Off / ready Reset error
• After resetting the current error, further errors may be
pending which must be reset as well.
• The status-determining error is displayed in C00168
.
• The current error is displayed in C00170
.
C00002/20 0: Off / ready Reserved
C00002/21 0: Off / ready Delete logbook
• All entries in the controller logbook will be deleted.
• In the logbook, information on the error history is
saved.
C00002/22 0: Off / ready Reserved
C00002/23 0: Off / ready Identify motor parameter
• This device command is serves to carry out an
automatic identification of the motor parameters.
• The device command is only carried out if the
controller is in the "Switched On" status
• In order to identify the motor parameters, the
controller must be enabled after this device
command.
C00002/24 0: Off / ready Reserved
C00002/25 0: Off / ready Reserved
C00002/26 0: Off / ready CAN reset node
• Reinitialise "CAN on board" interface.
• Required when changing the baud rate, node address,
or identifiers.
System bus "CAN on board"
C00002/27 0: Off / ready Reserved
C00002/28 0: Off / ready Reserved
C00002/29 0: Off / ready Reserved
C00002/30 0: Off / ready Reserved
C00002/31 0: Off / ready Reserved
C00002/32 0: Off / ready Reserved
; Read access ; Write access CINH PLC STOP ; No transfer COM MOT Scaling factor: 1
Parameter | Name:
C00002 | Controller commands
Data type: UNSIGNED_8
Index: 24573
d
= 5FFD
h
efesotomasyon.com - Lenze
To Next Page
Loading...