8400 HighLine | Parameter setting & configuration
Device control (DCTRL)
66 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
How to get to the parameterisation dialog of the device control:
1. In the »Engineer«, go to Project view and select the 8400 controller.
2. Go to Workspace and change to the Application parameters tab.
3. Go to the Overview dialog level and click the Drive interface button.
Parameterisation dialog in the »Engineer«
The parameterisation dialog shows the input / output signals and the internal signal flow
of the LS_DriveInterface
system block which displays the device control in the function
block editor:
Range / Meaning Display parameter
Display of the control word via system bus (CAN) C00136/2
Display of the control word via communication module (e.g. PROFIBUS) C00136/1
Display of the internal state machine and the current device state C00137
Display of all active sources of a controller inhibit C00158
Display of all active sources of a quick stop C00159
Display of the status word of the device control C00150
efesotomasyon.com - Lenze
To Next Page
Loading...