8400 HighLine | Parameter setting & configuration
Working with the FB Editor
Reconfiguring the predefined interconnection
862 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
3. If the elements are to be copied into a function block interconnection of another
project device, change to the corresponding interconnection via the project view.
4. Go to the context menu and select the Paste command (or <Ctrl>+<v>).
5. Go to the Insert FB interconnection dialog box and select the elements to be
inserted from the clipboard.
• Detailed information on this dialog box can be obtained from the following
subchapter "Insert options for copied elements
". ( 863)
6. Click Insert to insert the selected elements into the target interconnection as
defined.
• Only possible if at least one element in the list has been selected for insertion.
• Insertion is also possible via the <Enter> button if at least one element is
selected in the list for insertion.
• The original layout and the relative position of the inserted blocks to each other
are maintained.
• When copying across the devices, you also insert the corresponding separate
technical objects (e.g. port definition).
• The inserted elements are deleted from the list. If the list is empty, the dialog
box is closed and the connections are inserted depending on the selected
option.
7. If there are still elements to be entered in the list, repeat steps 5 and 6 until all
elements are inserted as intended.
8. Press Close to stop the insertion and close the dialog box.
• You can also use <Esc> or <Enter> to close the dialog box if "Insert" is not active.
• The elements inserted into the target interconnection so far are maintained.
• The connections for the blocks inserted so far are inserted depending on the
selected option.
efesotomasyon.com - Lenze
To Next Page
Loading...