Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 102/970
Disabled
Command Mode
Global Config
6.2.3.19 switchport priority
This command configures the default 802.1p port priority assigned for untagged packets for a
specific interface.
Syntax
switchport priority <0-7>
<0-7> - The range for the priority is 0 - 7.
Default Setting
0
Command Mode
Interface Config
This command configures the port priority assigned for untagged packets for all ports presently
plugged into the device. Any subsequent per port configuration will override this configuration
setting.
Syntax