QUANTA LB4M - Queue Cos-Queue Traffic-Shape

UANTA COMPUTER INC.
Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 413/970
queue on a "per-port" basis.
Default Setting
None
Command Mode
Interface Config.
This command activates the strict priority scheduler mode for each specified queue on a
device.
Syntax
queue cos-queue strict all <queue-id-0> [<queue-id-1> …
……
… <queue-id-6>]
no queue cos-queue strict all <queue-id-0> [<queue-id-1> …
……
… <queue-id-6>]
no - This command restores the default weighted scheduler mode for each specified
queue on a device.
Default Setting
None
Command Mode
Global Config.
6.21.2.5 queue cos-queue traffic-shape
This command specifies the maximum transmission bandwidth limit for the interface as a whole.
Also known as rate shaping, this has the effect of smoothing temporary traffic bursts over time
so that the transmitted traffic rate is bounded.