Layer 2,3,IPv6+QoS Switch
_____________________________________________________________________________
Layer 2,3,IPv6+QoS Network Switch User Manual Version 0.1 Page: 232/970
Global Config
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using. The Configuration Identifier Revision Level is a
number in the range of 0 to 65535.
Syntax
spanning-tree configuration revision <0-65535>
no spanning-tree configuration revision
<value> - Revision Level is a number in the range of 0 to 65535.
no - This command sets the Configuration Identifier Revision Level for use in identifying
the configuration that this switch is currently using to the default value, that is, 0.
Default Setting
0
Command Mode
Global Config
6.4.2.4 spanning-tree mode
This command sets the Force Protocol Version parameter to a new value. The Force Protocol
Version can be one of the following:
1. stp - ST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1d functionality
supported)
2. rstp - RST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1w
functionality supported)
3. mstp - MST BPDUs are transmitted (IEEE 802.1s functionality supported)
Syntax
To Next Page
Loading...
Need help?
General
